Cylinder Block, Liners, Pistons and Rods/Install Piston Cooling Orifices and Gallery Plugs 4. Measure cylinder block top deck flatness using D05012ST Precision Straightedge and feeler gauge. Resurface as required. CYLINDER BLOCK TOP DECK SPECIFICATIONS Maximum Out-of-Flat (Over Entire Length or Width) . . . . . . . . . . . . . . . . . . . . . 0.10 mm (0.004 in.) Straightness per Any 305 mm (12 in.) Length . . . . . . . . . . . . . . . . . . . . . . 0.025 mm (0.001 in.) Minimum Main Bearing Bore Centerline-to- Top Deck Distance . . . . . . . . . . . . . . . . . . . . . . . . . . 352.35 mm (13.872 in.) IMPORTANT:
The centerline of the main bearing bore-to-top deck of cylinder block MUST be 352.35—352.50 mm (13.872—13.878 in.). If not, replace cylinder block. 10 34 S11,2010,JW -19-16AUG94 INSTALL PISTON COOLING ORIFICES AND GALLERY PLUGS IMPORTANT: A piston cooling orifice failure could cause damage to pistons, piston pins, rod pin bushings, and liners. If a piston cooling orifice is left out, low or no oil pressure will result. 1. Install all six piston cooling orifices (A) and tighten to 11 N·m (97 lb-in.). 2. Install new oil and water gallery plugs as required, if removed. RG5811 -UN-12AUG91 CTM42 (24MAR95) 10-34 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G10,10-19-29OCT92 160101 PN=119