Cylinder Block, Liners, Pistons and Rods/Install Liner Shims—If Required INSTALL LINER SHIMS—IF REQUIRED If the liner flange thickness is within specification, but recorded standout was no more than 0.08 mm (0.003 in.) BELOW top deck of block, install liner shims on bottom of liner flange. The liner shim is 0.05 mm (0.002 in.) thick. A maximum of two liner shims may be used per cylinder, as required. Shims have tangs in the I.D. to help hold them in place against bottom of liner flange during liner installation. 1. Make sure counterbore in block is clean and free of burrs. Install liner(s), and shim(s), in block bore without O-rings.
Secure liners with cap screws and washers as done previously. Tighten cap screws to 68 N·m (50 lb-ft). Liner standout MUST NOT exceed 0.102 mm (0.004 in.) after shim installation. 2. Measure liner standout again at 1, 5, 7, and 11 O’clock positions. Record measurements. If standout is still not within specification, remove liner and determine cause. 10 36 If standout is within specification, proceed to next step. RG,CTM6,G10,2 -19-08MAR94 CTM42 (24MAR95) 10-36 6076 Diesel Engines—S.N. (500000— ) 160101 PN=121