John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Remove Crankshaft Rear Oil Seal Housing REMOVE CRANKSHAFT REAR OIL SEAL AND WEAR SLEEVE (WITH OIL SEAL HOUSING INSTALLED) Using JDG719 Seal Puller Adapter along with JDE38-2 Shank and JDE38-3 Slide Handle is the preferred method for removing the crankshaft rear oil seal. If JDG719, JDE38-2, and JDE38-3 are not available, JDG22 Seal Remover can be used to remove the seal. Follow same procedure for both pullers. IMPORTANT: If rear oil seal is replaced, also replace rear wear sleeve (as a matched set). RG5819 -UN-12AUG91 RG6467 -UN-26OCT92 NOTE: If oil seal housing is to be removed, remove seal and wear sleeve after housing is removed.

See REMOVE REAR OIL SEAL HOUSING AND WEAR SLEEVE (WITH ENGINE DISASSEMBLED), later in this group. 1. Remove rear drive hub (if equipped) and flywheel. See REMOVE FLYWHEEL later in this group. 2. Drill two small holes approximately 20˚ apart in bottom of seal casing. Install sheet metal screws in seal casing with JDG22 Seal Remover attached. NOTE: It may be necessary to drill a small hole in seal at one or two other locations to aid in removal. 15 9 3. Cock seal at 6 O’clock position (180˚ opposite drilled hole) using a small punch and carefully pull seal from housing. RG,CTM42,G15,2 -19-03MAY93 CTM42 (24MAR95) 15-9 6076 Diesel Engines—S.N. (500000— ) 160101 PN=138