John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Remove Crankshaft Rear Oil Seal Housing 4. Assemble JDG790 Rear Wear Sleeve Puller and position onto crankshaft flange with wear sleeve seated in jaws. 5. Securely tighten band clamp in groove on OD of jaws. 6. Tighten forcing screw with disc centered in crankshaft flange until wear sleeve is removed from crankshaft. RG6468 -UN-26OCT92 RG,CTM42,G15,50-19-29OCT92 Clean OD of crankshaft flange with cleaning solvent, acetone, or any other suitable cleaner that will remove sealant.

(Brake Kleen, Ignition Cleaner and Drier are examples of commercially available solvents that will remove sealant from flange.) 15 10 Look for nicks or burrs on wear ring surface and bore in flywheel housing. If necessary, use a polishing cloth. Finish cleaning by wiping flange with a clean rag. Any small nicks should be removed with 180-grit or finer polishing cloth. RG5822 -UN-12AUG91 Check oil seal housing runout as explained later in this group. RG,CTM42,G15,4 -19-29OCT92 CTM42 (24MAR95) 15-10 6076 Diesel Engines—S.N. (500000— ) 160101 PN=139