Crankshaft, Main Bearings and Flywheel/Install Crankshaft Rear Oil Seal and Wear Sleeve INSTALL CRANKSHAFT REAR OIL SEAL AND WEAR SLEEVE (WITHOUT ENGINE DISASSEMBLY) NOTE: These instructions are for use when the oil seal housing and oil pan would not be removed. Refer to INSTALL CRANKSHAFT REAR OIL SEAL AND WEAR SLEEVE (WITH ENGINE DISASSEMBLED), later in this group, for instructions with oil seal housing and oil pan removed. RG4639 -UN-14DEC88 1. Apply a light coating of LOCTITE 609 Retaining Compound, or equivalent, completely around the leading edge of crankshaft flange. Wipe away any sealant that may have gotten on ID of seal housing bore. 2.
Install JDG477 (85) Pilot (A) on end of crankshaft using the Allen head cap screws (B) supplied with tool set. Tighten cap screws securely. IMPORTANT: Handle seal and wear sleeve assembly carefully. If assembly becomes separated, discard these parts and install a new assembly. (See CRANKSHAFT REAR OIL SEAL AND WEAR SLEEVE HANDLING PRECAUTIONS, later in this group.) 15 11 3. Carefully start oil seal/wear sleeve assembly (C) over JDG477 (85) Pilot and crankshaft flange with open side of seal toward engine. IMPORTANT:
When installing the JDG478 Driver on JDG477 (85) Pilot and crankshaft flange to position oil seal/wear sleeve assembly, locate crossbar of installer at right angle (90˚) to Allen head cap screws. This allows the crossbar to bottom on pilot, not head of cap screws, assuring correct installation. S11,2015,GQ -19-16AUG94 CTM42 (24MAR95) 15-11 6076 Diesel Engines—S.N. (500000— ) 160101 PN=140