John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Inspect Vibration Damper 4. Position JDG478 Driver (A) so that hole in the cross plate goes over threaded stud of pilot. Install washer and nut on stud. 5. Tighten nut to draw JDG478 Driver in until crossbar bottoms on JDG477(85) Pilot. When the tool bottoms, seal and wear ring assembly (B) will be correctly positioned. RG4640 -UN-14DEC88 6. Remove JDG476(85) Tool Set from engine. S11,2015,GR -19-11JUN93 INSPECT VIBRATION DAMPER IMPORTANT: Do not immerse the vibration damper or the damper pulley in cleaning solvent. Doing so may damage the rubber portions of these components. Never apply thrust on outer ring of damper.

Damper is sensitive to impact damage, such as being dropped or struck with a hammer. RG5823 -UN-05SEP91 The damper assembly is not repairable and should be replaced every 5 years or 4500 hours, whichever occurs first, or whenever crankshaft is replaced. 15 12 1. Remove fan belts (shown removed). 2. Inspect damper for torn or split rubber protruding from damper, ring shift toward front or back of damper, or slippage of the ring (reference chisel marks). Replace damper if any defects are found. 3. Grasp vibration damper (A) with both hands and attempt to turn it in both directions. If rotation is felt, damper is defective and should be replaced.

RG,CTM42,G15,5 -19-16AUG94 CTM42 (24MAR95) 15-12 6076 Diesel Engines—S.N. (500000— ) 160101 PN=141