Crankshaft, Main Bearings and Flywheel/Remove Crankshaft REMOVE CRANKSHAFT 1. Rotate crankshaft using JDE81-1 Flywheel Turning Tool until connecting rod caps can be removed easily. You will be able to remove two rod caps at each position. RG5806 -UN-12AUG91 RG5834 -UN-12AUG91 2. Remove all connecting rod caps (A) with bearings (B), then remove No. 1 and 7 main bearing caps and bearings. See REMOVE PISTONS AND CONNECTING RODS in Group 10. N CAUTION: Crankshaft is very heavy. Plan a proper handling procedure to avoid injury. NOTE: Install a screw on each end of crankshaft to aid in lifting crankshaft. 3. Attach a lifting strap to crankshaft.
Using proper lifting equipment, carefully raise crankshaft out of cylinder block. 4. Clean crankshaft, especially oil passages, using solvent and compressed air. 5. Put crankshaft on clean V-blocks. If wear sleeve has not been removed from crankshaft, the following procedures may be used. However, removing wear sleeve using JDG790 Wear Sleeve Puller Kit while crankshaft is installed in engine is the preferred method. 15 29 • Use JDG790 Wear Sleeve Puller to remove wear sleeve from crankshaft, as described earlier in this group. Position crankshaft rod journals in V-blocks so that crankshaft does not rotate while removing wear sleeve.
• Use the ball side of a ball peen hammer and tap wear sleeve across its width in a straight line (to deform and stretch sleeve). • Score (A), but do not cut, the wear sleeve in several places around OD with a blunt chisel. CTM42 (24MAR95) 15-29 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G15,18-19-16AUG94 160101 PN=158