Crankshaft, Main Bearings and Flywheel/Inspect Crankshaft INSPECT CRANKSHAFT NOTE: If the crankshaft damper damage was discovered during teardown, it is recommended that the crankshaft be magna-fluxed. This will verify whether or not it has microscopic cracks or fissures. (See INSPECT VIBRATION DAMPER, earlier in this group.) The vibration damper should be replaced whenever the crankshaft is replaced. 4. Inspect the keyway for evidence of cracks or wear. Replace crankshaft as necessary. 5. Carefully inspect the rear hub of the crankshaft in the area of the wear sleeve contact surface for evidence of a rough or grooved condition. Any imperfections in this area will result in oil leakage.
Slight ridges may be cleaned up with emery cloth and crocus cloth. 1. Thoroughly clean crankshaft. Clear restrictions from all oil passages. 6. Check each journal for evidence of excessive overheating or discoloration. If either condition exists, replace crankshaft since heat treatment has probably been destroyed. 2. Inspect crankshaft for signs of load stress, cracks, or scratches on journals. Also check each journal for evidence of excessive overheating or discoloration. If either condition exists, replace crankshaft since heat treatment has probably been destroyed. 3. Inspect (front) crankshaft gear and (rear) oil pump drive gear for cracks, chipped teeth, or excess wear.
Replace gear(s) as required. (See REPLACE FRONT CRANKSHAFT GEAR and REPLACE CRANKSHAFT OIL PUMP DRIVE GEAR, later in this group.) 15 30 RG,CTM42,G15,93-19-16AUG94 CTM42 (24MAR95) 15-30 6076 Diesel Engines—S.N. (500000— ) 160101 PN=159