John Deere 400 6076 — John Deere 400 6076 User Manual

Cooling System/Replace Bearing in Injection Pump Drive Gear Mounted Fan Drive REPLACE BEARING IN INJECTION PUMP DRIVE GEAR COVER MOUNTED, FAN DRIVE RG6441 -UN-13OCT92 A—Bearing B—Fan Pulley C—Injection Pump Drive D—Bearing Shaft Installed Gear Cover Dimension • To Disassemble Fan Drive: • To Assemble Fan Drive: 1. Remove injection pump drive gear cover (C) and fan pulley assembly from timing gear cover. IMPORTANT: Support fan pulley on a flat, firm surface and press on bearing outer race to prevent damage to the bearing. 2. Support front face of injection pump gear cover and press bearing (A) and pulley (B) out of cover. 1. Install new bearing into pulley against stop. 3.

Support front face of fan pulley and push bearing out of pulley. Discard bearing. IMPORTANT: Support injection pump drive gear cover on machined mounted surface and press on inner shaft to prevent damage to bearing. 4. Thoroughly inspect cover and pulley for cracks or damage. Measure parts and compare readings with specifications given below. Replace parts as necessary. 25 12 2. Press bearing into cover. End of shaft should be 3.43—3.69 mm (0.135—0.145 in.) from cover mounting surface (D). INJECTION PUMP DRIVE GEAR COVER MOUNTED FIXED FAN PULLEY SPECIFICATIONS Bearing OD (Pulley End) . . . . . . . . . . . . . . 47.612—47.625 mm (1.8745—1.8750 in.) 3.

Hold cover firmly and turn fan pulley by hand to assure bearings rotate freely. Bearing OD (Cover End) . . . . . . . . . . . . . . 25.387—25.400 mm (0.9995—1.0000 in.) 4. Using new gasket, install cover onto timing gear cover. Tighten cap screws to 27 N·m (20 lb-ft). Fan Pulley Bore ID . . . . . . . . . . . . . . . . . . 47.576—47.612 mm (1.8731—1.8745 in.) 5. Install fan and V-belts. Refer to the appropriate operator’s manual for proper belt tensioning. Drive Gear Cover ID . . . . . . . . . . . . . . . . . 25.336—25.362 mm (0.9975—0.9985 in.) CTM42 (24MAR95) 25-12 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G25,40-19-14FEB95 160101 PN=231