John Deere 400 6076 — John Deere 400 6076 User Manual

Cooling System/Inspect and Check Belt Tensioner Spring Tension INSPECT AND CHECK BELT TENSIONER SPRING TENSION NOTE: The pulleys and the spring tensioner are not serviceable. If spring tension is not within specification, replace tensioner assembly. RW21153 -UN-17JUN92 RW21151 -UN-17JUN92 1. Release tension on belt using a long-handle 1/2 in. drive tool (A). Remove belt from the alternator pulley. 2. Release the tension on the tension arm and remove drive tool. 3. Put a mark (B) on swing arm of tensioner as shown. 4. Measure 21 mm (13/16 in.) from (B) and put a mark (C) on the mounting bracket. 5. Rotate the arm using a torque wrench (positioned as shown) until mark (B) and (C) are aligned.

RW21152 -UN-17JUN92 6. Note the torque wrench measurement and compare with specification below. Replace tensioner assembly as required. SPRING TENSION Specification . . . . . . . . . . . . . . . . . . . . . . 24—28 N·m (17—21 lb-ft) A—1/2 in. Drive Tool B—Tension Arm Mark C—Mounting Bracket Mark RG,CTM42,G25,46-19-17MAR95 25 13 CTM42 (24MAR95) 25-13 6076 Diesel Engines—S.N. (500000— ) 160101 PN=232