John Deere 400 6076 — John Deere 400 6076 User Manual

Cooling System/Remove Water Pump REPLACE BELT TENSIONER ASSEMBLY 1. Release tension on pulley (B) and remove belt, (shown removed). 2. Remove cap screw (A) and remove the tensioner assembly. RW21154 -UN-17JUN92 NOTE: Locator pin in tensioner base fits in hole in injection pump drive gear cover to assure proper positioning. 3. Install tensioner and tighten cap screw to 50 N·m (37 lb-ft). 4. Check spring tension on newly installed tensioner. (See INSPECT AND CHECK BELT TENSIONER SPRING TENSION earlier in this group.) 5. Install belt and position onto tensioner. RG,CTM42,G25,47-19-17MAR95 REMOVE WATER PUMP N CAUTION:

Explosive release of fluids from pressurized cooling system can cause serious burns. Wait until engine is cool enough to touch with bare hands before draining coolant. Slowly loosen radiator cap to first stop to relieve pressure. RG5836 -UN-28AUG91 25 14 IMPORTANT: Both water pump drain valve and block drain valve must be opened to completely drain both sides of the engine. 1. Open both water pump drain valve (A) and block drain valve (B) and drain coolant from engine. RG,CTM42,G25,11-19-14FEB95 CTM42 (24MAR95) 25-14 6076 Diesel Engines—S.N. (500000— ) 160101 PN=233