John Deere 400 6076 — John Deere 400 6076 User Manual

Air Intake And Exhaust System/Disassemble Turbocharger DISASSEMBLE TURBOCHARGER RG5857 -UN-13AUG91 A—Compressor Housing C—Center Housing Assembly D—Clamp Plates E—Turbine Housing B—Clamp Plates Cap or plug all openings (including exhaust and intake ports) and clean exterior of turbocharger with a pressure spray of cleaning solvent. Dry turbocharger with compressed air. 2. If equipped, straighten ears on lock plates. 3. Remove compressor housing cap screws, lock plates (if equipped), and clamps (B). IMPORTANT: When cleaning turbocharger do not spray directly into compressor cover or turbine housing. Spinning rotor with high pressure spray may cause bearing damage. 4.

Remove compressor housing. Gently tap compressor housing with a soft hammer, if necessary, to remove. Be careful not to damage compressor housing or compressor wheel. Put turbocharger on a clean flat surface. 5. Remove turbine housing cap screws, lock plates (if equipped), and clamps (D). 1. Scribe a location mark on the turbine housing (E), center housing (C), and compressor housing (A) to assist proper indexing of housings when turbocharger is assembled. 6. Remove turbine housing. Gently tap turbine housing with a soft hammer, if necessary, to remove. Be careful not to damage turbine housing or turbine wheel. 30 17 NOTE:

Some turbochargers may not have lock plates on compressor or turbine housing cap screws. CTM42 (24MAR95) 30-17 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G30,30-19-16AUG94 160101 PN=262