Air Intake And Exhaust System/Clean and Inspect Turbine and Compressor Housings CLEAN AND INSPECT TURBINE AND COMPRESSOR HOUSINGS 1. Thoroughly clean compressor housing (A) and turbine housing (C) using a commercially approved solvent only. Caustic solutions may damage housings. Dry housings with compressed air after cleaning. After a part is cleaned, place it on a clean flat surface and inspect as outlined below. • Inspect turbine housing for: —Wheel rub damage within the contour area that cannot be polished out with 60-grit silicon carbide abrasive cloth. RG5747 -UN-05AUG91 —Nicks, dents or warpage that could prevent proper sealing between the turbine housing and center housing.
—Corroded or stripped threaded mounting holes. • Inspect compressor housing for: —Wheel rub damage within the contour area that cannot A—Compressor Housing be polished out with 80-grit silicon carbide abrasive cloth. B—Compressor Clamp C—Turbine Housing —Nicks, dents, or warpage that could prevent proper D—Turbine Clamp sealing between the compressor housing and center housing. —Corroded or stripped threaded mounting holes. NOTE: Use new mounting cap screws when turbocharger is reassembled. 2. Clean all threads in housings with a tap. 3. Replace either housing if any of the above defects are found. 30 18 RG,CTM42,G30,31-19-15SEP94 CTM42 (24MAR95) 30-18 6076 Diesel Engines—S.N.
(500000— ) 160101 PN=263