Air Intake And Exhaust System/Replace Center Housing Assembly and Assemble Turbocharger REPLACE CENTER HOUSING ASSEMBLY AND ASSEMBLE TURBOCHARGER NOTE: Center housing and rotating assembly is serviced as a complete assembly; individual internal parts are not available. 1. Carefully transfer the scribed marks from the original center housing (C) to the replacement assembly, if necessary. Use the same procedure for the turbine housing (E) and compressor housing (A), if they are also being replaced. 2. Lay turbine housing on it’s side and install center housing assembly (C) into turbine housing (E).
Align scribed reference marks (scribed during disassembly) on turbine housing and center housing. RG5857 -UN-13AUG91 3. Apply a coat of PT569 NEVER-SEEZ Compound to cap screws. Install clamps (D), lock plates (if equipped), and cap screws. Tighten cap screws to specification. Bend lock plates up against head of cap screws. A—Compressor Housing TURBOCHARGER CAP SCREW TORQUE SPECIFICATIONS B—Clamp Plates C—Center Housing Assembly D—Clamp Plates Garrett/AiResearch E—Turbine Housing Turbine Housing-to-Center Housing . . . . . . . . . . . . 15.8—19.2 N·m (140—170 lb-in.) Compressor Housing-to-Backplate . . . . . . . . . . . . .
15.3—18.7 N·m (135—165 lb-in.) Schwitzer Turbine Housing-to-Center Housing . . . . . . . . . . . . . . . . 7—8 N·m (60—70 lb-in.) Compressor Housing-to-Backplate . . . . . . . . . . . . . . . . . 7—8 N·m (60—70 lb—in.) 4. Position compressor housing (A) onto center housing assembly (C). Align scribed reference marks (scribed during disassembly) on compressor housing and center housing. 5. Apply a coat of PT569 NEVER-SEEZ Compound to cap screws. Install clamps (B), lock plates (if equipped), and cap screws. Tighten cap screws to specification. IMPORTANT: DO NOT spin the rotor assembly with compressed air. Damage to bearings can occur when using compressed air. 30 19 6.
After assembly, spin rotating assembly by hand to check for binding and wheel rub. If either condition exists, disassemble turbocharger and determine the cause. 7. Prelube turbocharger bearings with clean engine oil before putting turbocharger into service. CTM42 (24MAR95) 30-19 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G30,33-19-29OCT92 160101 PN=264