Fuel System/Remove Hydraulic Aneroid Activator REPAIR ANEROID—IF EQUIPPED For aneroid repair and adjustment, have an authorized diesel repair station perform the work. The aneroid controls fuel delivery when intake manifold pressure is about 100 kPa (1.00 bar) (15 psi) or less. Therefore, all final adjustments are to be made on the test stand with aneroid mounted on injection pump. IMPORTANT: Correct aneroid adjustments are essential for satisfactory engine performance. Whenever aneroid has been disassembled or adjustments have been altered, injection pump (including aneroid) must be calibrated on test stand before releasing pump for service.
S11,3010,PG -19-14FEB95 REMOVE HYDRAULIC ANEROID ACTIVATOR—IF EQUIPPED NOTE: The hydraulic aneroid activator is located on back side of governor housing next to cylinder block. RG3546 -UN-20DEC88 1. Remove injection pump as described later in this group. 2. Remove special screw (A), copper washers (B) and banjo connector (C). Discard copper washers. 3. Remove spring (D), restricter wire (E) and capillary valve (F) from activator housing (G). Remove activator A—Special Screw housing. B—Copper Washer (2 used) C—Banjo Connector NOTE: Do not bend restricter wire or other activator D—Spring parts.
E—Restricter Wire F—Capillary Valve G—Activator Housing 35 21 CTM42 (24MAR95) 35-21 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G35,70-19-14FEB95 160101 PN=298