Fuel System/Injection Nozzle Specifications INJECTION NOZZLE SPECIFICATIONS A new nozzle or a used nozzle with a new spring (A), should open at approximately the following pressures. A used nozzle that has been rebuilt with a new spring and/or valve should be reset to same pressures as a new nozzle. New nozzle opening pressures are: RG3410 -UN-20DEC88 New Nozzle Opening Pressures (by nozzle tip size)** 7 x 0.22 mm, 7 x 0.23 mm, 7 x 0.255 mm . . . . . . . . . . . . . 29 000—30 200 kPa (290—302 bar) (4200—4370 psi) On nozzles which have been in service, spring (A) and spring seat (B) will have taken a normal set.
In this case, opening pressure is satisfactory if it meets or exceeds used nozzle minimum opening pressure given below, but does not exceed new opening pressure given above. Used nozzle minimum opening pressures are: Used Nozzle Minimum Opening Pressures (by nozzle tip size)** 7 x 0.22 mm, 7 x 0.23 mm, 7 x 0.255 mm . . . . . . . . . . . . . . . 26 200 kPa (262 bar) (3800 psi) Shims (C) of different thickness are available for changing opening pressure adjustment. Each 0.05 mm (0.002 in.) of shim thickness changes opening pressure approximately 700 kPa (7 bar) (100 psi). IMPORTANT: ALWAYS use John Deere nozzle adjusting shims which are specially hardened. Other shims will not be satisfactory.
If nozzle opening pressures are not correct, disassemble injection nozzles (as described in this group) and change shims until nozzles open at proper new nozzle pressure given above. The difference in nozzle opening pressures between cylinders in an engine should not exceed 350 kPa (3.5 bar) (50 psi). 35 44 **See ASSEMBLE FUEL INJECTION NOZZLE later in this group for nozzle tip size identification. CTM42 (24MAR95) 35-44 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G35,31-19-14FEB95 160101 PN=321