John Deere 400 6076 — John Deere 400 6076 User Manual

Fuel System/Install Fuel Injection Nozzles INSPECT AND CLEAN NOZZLE SEATING SURFACE 1. Inspect nozzle seating surface for carbon deposits. 2. If seat is not clean, use the JDG609 Nozzle Seat Reamer to remove carbon. Stop using tool when seat comes clean. 3. Insert a 13 mm (1/2 in.) tapered hardwood dowel to plug the nozzle tip bore. R26860N -UN-20DEC88 4. Blow out debris from nozzle cavity with compressed air; then remove wood dowel. RG,CTM42,G35,38-19-02OCT92 INSTALL FUEL INJECTION NOZZLES 1. Apply PT569 NEVER-SEEZ compound to gland nut threads and nozzle barrel (arrows). Be sure that NEVER-SEEZ compound was also applied to inside bore of gland nut during assembly. RG5888 -UN-19AUG91 NOTE:

Applying NEVER-SEEZ compound at these locations will help prevent possible seizure of gland nut to holder body. 2. Install a new R84472 Special Steel Washer (A) on tip end of assembled injection nozzle. IMPORTANT: Do not intermix injection nozzles of different suppliers or different tip sizes within a single engine. RG,CTM42,G35,39-19-03OCT92 3. Insert injection nozzle into cylinder head. Turn gland nut by hand to make sure it is threaded straight in cylinder head. 35 59 4. Use outer socket of JDE92 Nozzle Socket and turn gland nut down to remove most of the looseness. RG5889 -UN-19AUG91 5.

Rotate nozzle holder so hole for leak-off connector threads (A) are facing straight out from cylinder head. CTM42 (24MAR95) 35-59 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G35,41-19-15SEP94 160101 PN=336