Fuel System Operation and Test/Test Mechanical Fuel Supply Pump for Leaks DIAGNOSE MECHANICAL FUEL SUPPLY PUMP MALFUNCTION—CONTINUED Symptom Problem Solution Diesel Fuel Leaking Into Injection Worn spindle and/or pump housing. Replace pump. Pump Crankcase Defective O-ring seal. Replace O-ring seal. Supply Pump Will Not Pump on Supply pump from A-Series Install correct supply pump on P-Size Pump Injection pump may have been injection pump. installed. 115 19 Supply Pump Mounting Flange Supply pump from P-Series Install correct supply pump on Breaks When Mounted on A-Size Injection pump may have been injection pump. Pump and Operated installed.
RG,CTM42,115,21-19-28OCT92 TEST MECHANICAL FUEL SUPPLY PUMP FOR LEAKS Fuel delivery pressure should be checked before removing supply pump from injection pump. (See CHECK MECHANICAL FUEL SUPPLY PUMP OPERATION, in Group 115.) 1. Connect compressed air line (A) to a pressure gauge (B) and to supply pump inlet fitting. Air line should have a regulating valve to control pressure. 2. Cap or plug supply pump outlet fitting (C). RG5894 -UN-19AUG91 3. Submerge supply pump in a container of clean diesel fuel. Regulate air pressure to 200 kPa (2.0 bar) (29 psi). 4. Move roller tappet (Nippondenso pumps) or spindle (Bosch pumps) in and out by hand.
No air bubbles should appear around roller tappet or spindle bore. NOTE: If bubbles appear, it is an indication that either the O-ring seal is defective or spindle or tappet is worn (or possibly both). IMPORTANT: Serious injection pump or engine damage could occur, if enough diesel fuel leaks past spindle and seal. Fuel leakage past spindle dilutes engine oil. CTM42 (24MAR95) 115-19 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G35,9 -19-28OCT92 160101 PN=402