John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Head and Valves/Grind Valve Seats GRIND VALVE SEATS IMPORTANT: Valve seat grinding should only be done by experienced personnel familiar with equipment and capable of maintaining required specifications. ALWAYS keep work area clean when grinding valve seats. Using JT05893 Heavy-Duty Seat Grinder Set, grind valve seats to obtain correct valve recess in cylinder head. (See MEASURE VALVE RECESS earlier in this group.) Be sure valve guide bores are clean before grinding valve seats. (See CLEAN VALVE GUIDES earlier in this group.) R26143N -UN-09DEC88 RG5248 -UN-06DEC88 If valve seats need grinding, do not grind too long.

Only a few seconds are required to recondition the average valve seat. Avoid the tendency to grind off too much. Do not use too much pressure. While grinding, support the weight of the dresser to avoid excessive pressure on the stone. 05 25 1. Check the seat width and contact pattern between the seat and valve with bluing. Seat width MUST BE maintained within specification. Use a vernier caliper or scale to measure seat width. Thoroughly clean seat area after grinding and replace valves and valve seat inserts as necessary. NOTE: Valve seat width can be reduced with a narrowing stone. This will change the angle at the top of the seat and increase the diameter.

If valve seat width is too narrow, valve may burn or erode. Varying the width changes the fine contact between valve face and seat. 2. ALWAYS measure valve seat runout after grinding using D11010KW Eccentrimeter. VALVE SEAT SPECIFICATIONS A—Valve Seat Insert B—Valve Seat Angle . . . . . . . . . . . . . . . . . . . . . . . . . . 30˚ ±0.50˚ C—Valve Seat Width —Exhaust . . . . . . . . . . . . . . . . . . 2.0—3.8 mm (0.079—0.150 in.) —Intake . . . . . . . . . . . . . . . . . . . 1.4—3.8 mm (0.055—0.150 in.) D—Maximum Valve Seat Runout . . . . . . . . . . 0.051 mm (0.0020 in.) IMPORTANT: Blend or radius all sharp edges after grinding valve seats.

Always check valve recess in cylinder head after grinding as described later. CTM42 (24MAR95) 05-25 6076 Diesel Engines—S.N. (500000— ) S11,2005,MJ -19-28OCT92 160101 PN=68