Cylinder Head and Valves/Remove Valve Seat Inserts and Measure Bores REMOVE VALVE SEAT INSERTS AND MEASURE BORES IN CYLINDER HEAD In some cases the inside diameter of the valve seat bore may become damaged or oversized and require machining. In this case, oversize inserts are available in 0.25 mm (0.010 in.) oversize only. RG5306 -UN-06DEC88 IMPORTANT: Be careful not to damage cylinder head when removing seats. 1. Remove valve seat insert (if necessary) with JDE41296 Valve Seat Puller (A). Adjusting screw on puller may need to be retightened during removal of inserts. NOTE: On some engines, removal of valve seat inserts with the JDE41296 Puller may not be possible.
An alternate removal method is to weld two or three short beads (use an arc welder) equidistant from each other around the face of insert. Allow seat to cool and carefully pry out the insert(s) with a screwdriver. 05 26 IMPORTANT: If an arc welder is used to remove valve seat inserts, protect entire combustion face and valve throat area from weld spatter. 2. After removal of inserts, thoroughly clean area around valve seat bore and inspect for damage or cracks. S11,2005,ML -19-28OCT92 CTM42 (24MAR95) 05-26 6076 Diesel Engines—S.N. (500000— ) 160101 PN=69