Cylinder Head and Valves/Measure Cylinder Liner Standout (Height above Block) MEASURE CYLINDER LINER STANDOUT (HEIGHT ABOVE BLOCK) 1. Bolt down liners using cap screws and flat washers in the seven locations as shown. Flat washers should be at least 3.18 mm (1/8 in.) thick. Tighten cap screws to 68 N·m (50 lb-ft) to achieve an accurate standout reading. RG5829 -UN-12AUG91 RG5813 -UN-08MAR94 NOTE: Liners having obvious defects must be replaced. 2. Using JDG451 Gauge along with D17526CI (English) or D17527CI (Metric scale) Dial Indicator (B) or KJD10123 Gauge to measure the height (C) of bolted down liners (A) that are not obviously defective before removal from block (D). NOTE:
Variations in measurement readings may occur within one cylinder and/or between adjacent cylinders. 05 30 3. Measure each liner in four places, approximately at 1, 5, 7 and 11 O’clock positions as viewed from the rear of the engine (flywheel end). Record all measurements by cylinder number. 4. Remove any liner that does not meet standout specification at any location and install liner shims or replace piston/liner sets as necessary, as outlined in A—Cylinder Liner B—Dial Indicator Group 10. See INSTALL LINER SHIMS—IF REQUIRED. C—Liner Height D—Cylinder Block LINER HEIGHT SPECIFICATIONS Liner Height Above Block . . . . . . . . . . . . . . . . . .
0.050—0.127 mm (0.002—0.005 in.) RG,CTM42,G5,31 -19-16AUG94 CTM42 (24MAR95) 05-30 6076 Diesel Engines—S.N. (500000— ) 160101 PN=73