John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Head and Valves/Install Cylinder Head 7. Strike end of each valve with a soft mallet (A) three or four times to insure proper seating of the retainer locks. Repeat procedure for all remaining valves. Remember valve stem seals are installed onto exhaust valve stems only. RG3807 -UN-23FEB89 8. Measure valve recess as directed earlier in this group. RG,CTM42,G5,30 -19-28OCT92 INSTALL CYLINDER HEAD IMPORTANT: ALWAYS thoroughly inspect new cylinder head gasket for possible manufacturing imperfections. Return any gasket that does not pass inspection. 05 32 RG5245 -UN-06DEC88 Be sure cylinder head and block gasket surfaces are clean, dry, and free of any oil. 1.

Put a new head gasket on cylinder block. Do not use sealant on gasket; install dry. IMPORTANT: If cylinder head is lowered onto cylinder block and you discover that the head is not positioned correctly on locating dowels, remove cylinder head and install a new gasket. DO NOT try to reposition cylinder head on the same gasket again since the fire ring will possibly be damaged. 2. Lower cylinder head everly to correct position on block using appropriate lifting equipment. Make sure that head is positioned correctly over dowels. RG,CTM42,G5,40 -19-14FEB95 CTM42 (24MAR95) 05-32 6076 Diesel Engines—S.N. (500000— ) 160101 PN=75