John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Head and Valves/Cylinder Head Cap Screw Types CYLINDER HEAD CAP SCREW TYPES RG7226 -UN-22JUL94 A—ASTM Grade 180 Flanged-Head B—Flanged-Head Marked “SPECIAL” One of the two cylinder head cap screws shown will be found on the engine, depending upon when the engine was built. Grade 180 flanged-head cylinder head cap screws must be tightened using the “TORQUE-TURN” method. See TIGHTEN FLANGED-HEAD CYLINDER HEAD CAP SCREWS — GRADE 180, later in this group. 05 33 IMPORTANT: Cylinder head cap screw torque specifications and tightening procedures vary depending upon the grade or type of cap screw used, and the cylinder block casting number.

Cylinder head cap screws marked “SPECIAL” must be tightened using the “TORQUE-TO-YIELD” method. See TORQUE-TO-YIELD FLANGED-HEAD CAP SCREWS—GRADE 180 MARKED “SPECIAL” later in this group. Cylinder block casting numbers R116070, R119995, R119996, R119997, R119998 and R119999 use Grade 180 flanged-head cylinder head cap screws. These cap screws must be tightened using the “Torque-Turn” method. See TIGHTEN FLANGED-HEAD CYLINDER HEAD CAP SCREWS later in this group. IMPORTANT: DO NOT re-use cylinder head cap screws marked “SPECIAL”, they may be used only one time.

For cylinder blocks with casting numbers R122736, R122737, R122738, R122739, R122740 and R122741, the early engines were built with Grade 180 flanged-head cylinder head cap screws, and later engines are built with cylinder head cap screws marked “SPECIAL”. For service of these engines, either type of cylinder head cap screw can be used, although use of “SPECIAL” cylinder head cap screws is recommended. CTM42 (24MAR95) 05-33 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G5,41 -19-14FEB95 160101 PN=76