Cylinder Head and Valves/Clean, Inspect and Install Cylinder Head Cap Screws CLEAN, INSPECT AND INSTALL CYLINDER HEAD CAP SCREWS RG4471 -UN-28FEB94 IMPORTANT: All SAE Grade 180 flanged-head cap screws can be reused if they pass inspection EXCEPT for the flanged-head cap screws marked “SPECIAL”. These cap screws can be used only one time and only on cylinder blocks with casting numbers R116070, R119995, R119996, R119997, R119998, and R119999. 1. Clean entire length of cap screws (if reusing) to remove rust and scale using a wire brush and solvent. Dry cap screws with compressed air. 2. Inspect cap screws for corrosion damage and condition of threads.
ANY CAP SCREW WITH CORROSION OR OTHER IMPERFECTIONS MUST BE REPLACED. 05 34 IMPORTANT: DO NOT use multi-viscosity oils tolubricate cap screws. Only SAE30 engine oil may be used. 3. Dip entire cap screw in clean SAE30 engine oil. Allow excess oil to drip off. Arrow (A) points toward front of engine. 4. Install cap screws in proper location. Use the following cap screws in location as shown: Cap Screw Length Location on Cylinder Head 134 mm (5.2 in.) . . . . . . . . . . . . . . . . . . . . . . . . . . . 2, 3, 4, 5, 6, 7 149 mm (5.9 in.) . . . . . . . . . . . . . . . . . . . . . . . . 23, 25, 17, 21, 19 175 mm (6.9 in.) . . . . . . . . . . . . . . . . . .
1, 15, 14, 13, 12, 11, 10, 8 203 mm (8.0 in.) . . . . . . . . . . . . . . . . . . . . 16, 20, 22, 18, 26, 24, 9 RG,CTM42,G5,42 -19-17MAR95 CTM42 (24MAR95) 05-34 6076 Diesel Engines—S.N. (500000— ) 160101 PN=77