24.4.3 CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL l When removing stop the engine and wait for the oil temperature to go down, then turn the cap slowly to release the in- ternal pressure before removing the-cap. l If oil has been added to above the H mark, stop the engine and wait for the hydraulic oil to cool down, then drain the excess oil from the drain plug. Lower the blade to the ground in horizontal position, lower the ripper shank vertically and put the tip of the shank in contact with the ground. Stop the engine and wait for about 5 minutes before checking oil level. If oil level is between H and L in sight gauge 0, it is normal. 1. 2.
NOTICE Do not add oil if the level is above the H line. This will damage the hydraulic equipment and cause the oil to spurt out. 3. If the level is below the L mark, add engine oil through oil filler 0. For details of the oil to use, see “20. USE OF FUEL, COOL- ANT AND LUBRICANTS ACCORDING TO AMBIENT TEM- PERATURE”. 3-49