24. SERVICE PROCEDURE 24.4.4 CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST Checking The belt tension should normally deflect by approx. 13 to 17 mm (0.51 to 0.67 in) when pressed with the finger at a point mid- way between the alternator pulley and the drive pulley (approx. 10 kg (22 lb)). Alternator pully Drive pully Adjusting 1. Loosen bolts 0, 0 and nut 0. 2. Turn turnbuckle 0 and move alternator 0 so that the deflec- tion of the belt is approx. 13 mm (0.51 in) (approx. 10 kg (22 lb)). REMARK When adjusting the V-belt, do not attempt to push alternator directly with a bar or the like, but use a wood pad to prevent damage to the core. 3.
Tighten bolts and nuts 0, 0, and 0 to hold alternator 0 in position. When tightening nut 0, hold the bolt on both sides to pre- vent it from turning together with the nut. 4. Check each pulley for damage, and V-grooves and V-belt for wear. Particularly, check whether V-belt is in contact with bot- tom of V-groove through wear. Replace two belts at the same time if it has stretched, leaving no allowance for adjustment, or if there is a cut or crack on belt. When the belt is replaced, readjust its tension after running for an hour. 5. 6. 3-50