24. SERVICE PROCEDURE 24.6.4 CHECK OIL LEVEL IN RECOIL SPRING, ASSIST CYLINDER CASE, ADD OIL A WARNING When checking the oil level or adding oil, the system is under internal pressure, so loosen plugs 0 and 0, and check that the internal pressure is released. 1. Remove bolts 0, then remove cover 0. When removing the cover, be careful not to let dirt or sand get in. 2. Loosen plugs 0 and 0, and check that the internal press- ure is released. 3. Remove plug 0, and check that the oil level is up to level L (the point where the diameter changes). 4. If the oil level is low, add engine oil so that the oil reaches level H (the position of the side drill hole).
Use Class CD SAEIO engine oil regardless of the ambient temperature. 24.6.5 GREASE UNIVERSAL JOINT Apply grease to the grease fittings (4 places on diametri- cally opposite sides) shown by arrows. 3-60