24. SERVICE PROCEDURE 24.7 EVERY 2000 HOURS SERVICE Maintenance for every 250, 500 and 1000 hours should be carried out at the same time. 24.7.1 CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC OIL FILTER ELEMENT AND CLEAN STRAINER A WARNING The oil is at high temperature immediately after the ma- chine has been operated. Wait for the oil to cool down before changing the oil. l When removing oil filler cap 0, turn it slowly to re- lease the internal pressure, then remove it carefully. l When removing cover 8, undo the bolts (4 bolts) gradually to prevent the cover flying off under the force of spring 0. Prepare the following. a Container to catch drained oil:
Min 300 Q capacity Refill capacity: 300 Q (79.2 US gal, 66.0 UK gal) 0 1. Lower the blade and ripper on the ground securely, stop the engine and slowly turn the cap of oil filler 0 to re- lease the internal pressure. Then, remove the cap. 2. Loosen drain valve 8 on the top of the steering case to drain the oil. After draining, tighten valve @. When loosening drain plug 8, be careful to avoid getting oil on yourself. 3. Remove bolts 0 and cover 0, and take out spring 0, valve 0 and element 0. 4. Clean the removed parts and install new elements. Replace the O-ring at the same time. 3-62