24. SERVICE PROCEDURE 5. Remove cover 8 at the top of the hydraulic tank and lift up the top of rod @I from above to take out spring 0 and strainer 0. 6. Remove all dirt from the strainer, then wash in clean light oil or flushing oil. If strainer 0 is damaged, replace it with a new one. 7. Refit strainer 0 by inserting it into tank projecting part 0. 8. Then, refill the specified quantity of engine oil through oil filler 0. For details of the oil to use, see “20. USE OF FUEL, COOL- ANT AND LUBRICANTS ACCORDING TO AMBIENT TEM- PERATURE”. 9. Check that the oil is at the specified level. For details, see “24.4 EVERY 250 HOURS SERVICE”. 3-63