24. SERVICE PROCEDURE 24.7.2 CHANGE OIL IN FINAL DRIVE CASE, REPLACE FILTER ELEMENT A WARNING The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before starting the operation. There is danger that the oil may spurt out under in- ternal pressure, so to the side, and gradually turn the plug to release the internal pressure before removing the plug completely. Prepare the following. l Container to catch drained oil: Min. 70 II capacity l Refill capacity: (each) 70 II (18 US gal, 15 UK gal) The maintenance shall be made placing the machine on a horizontal plane. 1. Turn the final drive so oil filler plug 0 comes to the top. 2.
Remove oil filler plug 0 and drain plug 8 to drain the oil. Remove all the mud and dirt from around oil filler plug 0 before removing it. Be careful not to let any dirt or sand get in when adding oil. 3. After draining, tighten drain plug @. 4. Remove bolts 0, cover 0, spring @ and valve 0, then take out element 0. assembly 5. After removing element 0, clean the case interior and the removed parts, and install a new element. Replace the O-ring at the same time. 6. Refill the gear oil until oil overflows from plug hole 0, and tighten the plugs. For details of the oil to use, see “20. USE OF FUEL, COOL- ANT AND LUBRICANTS ACCORDING TO AMBIENT TEM- PERATURE”. 3-64