MAINTENANCE RELATING TO ENGINE ENGINE OIL DIESEL FUEL l Engine oil is critical because it engine, the heart of the machine. lubricates the Always use the fuel specified for the engine. Fuels other than the specifications can damage the engine or reduce the engine output. l Main services relating to engine oil are: 1) daily check of oil level, 2) check for contamination and 3) periodic replacement. Always fill the fuel tank at the end of the day’s operation. COOLANT When adding fuel, be careful not to let any water on top of the drum or at the bottom of the drum get into the fuel. l Coolant is used to cool the engine and to keep it in good working condition.
0 Check coolant level in the radiator daily and maintain it at the proper level. After the machine has run out of fuel or after the fuel filter has been replaced, bleed the air from the fuel line. l Forcoolant recommendations/specifications, refer to “COOLANT” under “LUBRICANTS, FUEL AND COOLANT”. RELATING TO HYDRAULIC SYSTEM 0 Use extreme caution when servicing the hydraulic system, because oil in the system soon after the operation is very hot. Also, high pressure is applied in the system not only during but also after the operation. l When a item, such as a hose, in the line is disconnected, check O-rings for damage and replace them if necessary.
l If a hydraulic component has been removed or any hydraulic line has been disconnected or removed, bleed the air from the hydraulic tank and system after completion of assembly. Bleed the air from the tank and system as described under “HYDRAULIC TANK” and/or “PPC (PROPORTIONAL PRESSURE CONTROL) CIRCUIT” in the section. l Services relating to the hydraulic system are: 1) weekly check of oil level, 2) periodic filter replacement and 3) periodic oil replacement. Always bleed the air from the circuit after replacing the filter or changing the hydraulic oil.
0 RELATING TO ELECTRICAL SYSTEM l If the wiring gets wet or the insulation is damaged, the electrical system leaks and this could result in hazardous malfunction of the machine. those specified by Komatsu Dresser Company. l Be careful to keep the electrical system free of water when washing the machine or when it rains. l Services relating to the electrical system are: 1) check fan belt tension, 2) check for damage or wear of the fan belt and 3) check the battery electrolyte level. l When working on the seashore, carefully clean the electrical system to prevent corrosion. l Never connect any optional power source to the fuse, starting switch, battery relay, etc.
Never remove or disassemble any electrical components installed on the machine. 0 l Never install any electrical components other than 3-4