MAINTENANCE RELATING TO LUBRICATION Lubrication is to help smooth operation of the machine and work equipment. It prevents the machinery from being subjected to excessive load and from getting caught or generating noise. 0 There are two lubricating methods; using oil and using grease. l Services relating to lubrication are: 1) check of oil levels, 2) periodic changing of oil and 3) adding grease for proper lubrication. overhaul purpose, and no greasing is required for them. Always use only the lubricants specified under “LUBRICANTS, FUEL AND COOLANT”.
After adding new grease, wipe off old grease that was forced out, especially on rotating parts that could be worn by sand and dirt adhering to them. The machine has grease fiiings in various places. Some of the fittings may not be mentioned in this manual. These fiiings are equipped for the Maintain oil at the proper level. Both too high and too low oil levels are not good for the machine. BLEEDING AIR BLEEDING AIR FROM HYDRAULIC TANK tank to bleed the air. After bleeding the air, tighten the air bleed plug (1). The hydraulic tank and system should be bleed free of air after the following: l Replacing the hydraulic oil and filter elements or cleaning the oil strainer.
l Removing a hydraulic component or disconnecting hydraulic piping. After reassembly, bleed the air from the hydraulic tank and system as follows: 1. Check and if necessary refill the hydraulic tank with oil up to the specified oil level of the sight gauge. NOTICE: Check the hvdraulic tank oil level and refill with oil frequently when bleeding the system. A 5. Recheck the hydraulic tank oil level and add oil as necessary. WARNING! At first, if the engine is operated at high speed or if the hydraulic cylinder is moved to the end of its stroke, the air in the cylinder may damage the cylinder piston packing, etc. 6.
Start the engine, increase the engine speed and repeat Steps 3 and 4 to bleed the air until no more bubbles come out from the bleed plug ports. 7. After bleeding the air, tighten the air bleed plug (1). Run the engine at low idle. One at a time, operate the hydraulic steering, bucket and lift arm cylinders four (4) to five (5) times, stopping 100 mm (3.9 in) from the end of its full stroke. * Tightening torque of bleed plug: 1.15 ? 0.15 kgm (8.3 f 1.0 Ibf ft/ 11.3 5 1.4 N-m) 8. Recheck the oil level in the hydraulic tank and add oil as necessary. After adding oil, tighten the oil filler cap securely.
Next, operate each hydraulic cylinder three (3) to four (4) times, to the end of its stroke, then stop the engine. Loosen the air bleed plug (1) on the hydraulic 3-5