MAINTENANCE BLEEDING AIR FROM THE WHEEL BRAKE HYDRAULIC CIRCUIT The wheel brake hydraulic circuit should be bleed free of air after the following: l Removing brake hydraulic component or as follows: A WARNING! When bleeding air from within the brake hydraulic circuit, always place blocks or chocks under the tires to prevent the machine from moving. 1. Check and if necessary refill the brake oil tank with oil up to the specified oil level of the sight gauge. NOTICE: Check the brake oil level and refill with oil frequently when bleeding the system. 2. Run the engine at low idle. Remove the protective cap of air bleed plug (A). 3.
Depress and hold the brake pedal and loosen air bleed plug (A) about 3/4 of a turn at one of the wheel brakes to bleed the air. After bleeding the air, tighten the air bleed plug and release the brake pedal. 4. Repeat the previous step to bleed the air until air bubbles stop coming out from the bleed plug port. After bleeding the air, tighten air bleed plug (A) and install the protective cap. 5. Recheck the brake oil level and add oil as neces- sary. 6. Repeat Steps 2 thru 5 to bleed the air at the remaining three (3) brakes. 7. Stop the engine. a. Recheck the oil level in the brake oil tank and add oil as necessary. After adding oil, tighten the oil filler cap securely.
* For further details, contact your distributor. 3-6