Komatsu — BLEEDING AIR FROM FUEL SYSTEM

MAINTENANCE Venting the high pressure lines When using the starting motor to vent the system, do not engage it for more than 30 seconds at a time: wait two minutes between engagements. * A WARNING! It is necessary to put the engine in the “RUN” position. Because the engine may start, be sure to follow all the safety precautions. Use the normal engine starting procedure. 1. Loosen fiiings (f) at the injectors, and crank the engine to allow entrapped air to bleed from the lines. Tighten the fiiings. X 17 LlZZZ160 WARNING! High pressure could cause penetration of the skin. 9 A WARNING!

Do not bleed a hot engine as this could cause the fuel to spill onto a hot exhaust manifold creating a danger of fire. A 2. Start the engine and vent one line at a time until the engine runs smoothly (at 700 rpm). LllAJOZ! L = OFF B = ON C = START 3-8