Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.15 RING GEAR 3. Check the amount of interference fit between the flywheel mounting shoulder and the ring gear. See Figure 1-89. The interference fit must be within the permissible values listed in Table 1-23. 1. Ring Gear 2. Flywheel Figure 1-89 Flywheel Ring Gear Interference Fit Table 1-23 Flywheel Ring Gear Specifications [a] Measure the flywheel shoulder diameter (B). [b] Measure the inside diameter of the new ring gear (A). [c] Determine the amount of interference fit by subtracting the ring gear inside diameter (A) from the flywheel shoulder diameter (B). [d] Make sure that the amount of interference fit lies between 0.295 and 0.645 mm (0.0116 and 0.0254 in.).

All information subject to change without notice. 1-102 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Specification, mm (in.) Flywheel Shoulder Diameter (for ring gear mounting) 432.450-432.645 (17.0256-17.0333) Hole for Mounting Clutch Pressure Plate M10 x 1.5 Ring Gear Inside Diameter 432.000-432.155 (17.0079-17.0140) Ring Gear/Flywheel Interference Fit 0.295-0.645 (0.0116-0.0254) Ring Gear/Flywheel Permissible Radial Runout 0.5 (0.02) Ring Gear Width 18.4-18.6 (0.72-0.73) Ring Gear Fitting Temperature 200-230°C (392-446°F)