Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL NOTICE: Be careful to heat the new ring gear as evenly as possible. If available, an oven can be used. Uneven heating of the ring gear can weaken the ring gear and reduce service life. 4. Heat the new ring gear to 200-230°C (392-446°F). 5. Press the heated ring gear completely onto the mounting shoulder of the flywheel. 6. Bore and tap the holes for the clutch mounting bolts. See Figure 1-90. The specifications are listed in Table 1-23. 1. Ring Gear 2. Flywheel Figure 1-90 Flywheel Ring Gear Cross Section [a] With the flywheel friction surface facing up (ring gear down), bore holes for the clutch mounting bolts. [b] Tap the bore holes with M10 x 1.5 metric threads.

7. Check the ring gear/flywheel radial runout. NOTE: With the ring gear pressed onto the flywheel, make sure the radial run-out of the ring gear does not exceed 0.5 mm (0.02 in.). 8. Install the flywheel on the crankshaft flange. Refer to section 1.14.2. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-103