Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.16 PILOT BEARING 1.16 PILOT BEARING The special tools listed below are required for this procedure: Engine Barring Tool (J–46392) 19mm Flywheel and Main Pulley Socket (J–45390) Flywheel Pilot Bearing Remover J-46170 Flywheel Pilot Bearing Installer J-46169 Slide Hammer J-6471–02 Driver Handle J-8092 Perform the following procedures for removal and installation of the pilot bearing. 1.16.1 Removal of Pilot Bearing Removal steps are as follows: 1. Remove the transmission. Refer to the appropriate vehicle service manual. 2. Remove the clutch from the flywheel. Refer to the appropriate vehicle service manual. 3. Install the engine barring tool (J–46392). Refer to section1.17.1. 4.

Using the 19mm socket (J–45390), remove eight flywheel socket-head bolts from the flywheel leaving one bolt across from each other on the bolt circle. 5. Install and finger tighten two M16 x 1.5 x 70 mm hex-head bolts (locally procured) across from each other in the flywheel. Position the two bolts with the flats of the bolt head parallel to the pilot bearing bore. See Figure 1-91. NOTE: The flats on the hex-head bolts must be parallel to the pilot bearing bore in order to have sufficient clearance to remove the pilot bearing. 1. Flywheel 2. M16 x 1.5 x 70mm Hex-Head Bolt Figure 1-91 Flywheel Bolt Positioning All information subject to change without notice.

1-104 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION