Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 4. Before installing the new rings, check the end gap. The correct end-gap measurements are listed in Table 1-34. Table 1-34 Piston Ring End-Gap Dimensions NOTE: Check the end gap of the upper two piston rings first. The garter spring must be removed from the third (lowest) piston ring before you can measure its end gap. [a] Place each ring squarely into the combustion area of a cylinder liner or cylinder. Measure the end gap using a feeler gauge. See Figure 1-118. Figure 1-118 Ring End Gap [b] Remove the spring garter from the third (lowest) ring. Measure its gap in the same way as the other two rings. All information subject to change without notice.

DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-133 Ring Designation Groove Gap When New, mm (in.) Maximum End Gap, mm (in.) Keystone I 0.45 to 0.60 (0.018 to 0.024) 1.0 (.039) Taper-Faced with Internal Angle II 0.40 to 0.55 (0.016 to 0.022) 1.0 (.039) Double-Chamfered Oil Control with Garter Spring III 0.40 to 0.55 (0.016 to 0.022) 1.0 (.039)