Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.19 PISTON, PISTON RING, AND CONNECTING ROD [c] Install the garter spring into the ring. The garter spring joint should be positioned 180 degrees from the gap (A) in the piston ring. See Figure 1-119. 1. Garter Spring 3. Garter Spring Joint 2. Piston Ring Figure 1-119 Garter Spring 5. Using the knob, set the maximum ring expansion stop on the piston ring pliers (J-46072) or equivalent to the corresponding piston diameter. Be careful not to over-expand the rings during installation. See Figure 1-120. 1. Ring Expansion Stop Knob 2. Piston Diameter (mm) Figure 1-120 Piston Ring Pliers (J-46072) All information subject to change without notice.

1-134 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION