EPA07 MBE 4000 SERVICE MANUAL 6. Make sure the word "TOP" on each ring is facing toward the crown of the piston. Install the rings in the reverse order of their removal; from the bottom to the top of the piston. 7. Offset the ring gaps alternately by 120 degrees. See Figure 1-121. Piston Figure 1-121 Piston Rings Offset 120 Degrees 8. Install the piston. Refer to section 1.19.2. 1.19.4 Replacement of Connecting Rod Bushing Replacement steps are as follows: All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-135