1.19 PISTON, PISTON RING, AND CONNECTING ROD NOTICE: Be careful to avoid damaging the bushing bore when removing the bushing. A damaged connecting rod can seize up suddenly, causing major engine repairs. 1. Rest the connecting rod on a flat surface. Using an appropriate drift, press the bushing out of the connecting rod. See Figure 1-122. 1. Bushing 2. Connecting Rod Figure 1-122 Connecting Rod Bushing 2. Check the bushing bore in the connecting rod. If surface material is missing from the bushing bore, replace the connecting rod. 3. Measure the inside diameter of the bushing bore in the small bore of the connecting rod.
If the measurement exceeds 57.019 mm (2.2448 in.), replace the connecting rod. Refer to section 1.19.1.2. NOTE: The inside diameter of the bushing bore and the outside diameter of the bushing must conform to the specifications listed in Table 1-35. This is necessary to obtain the required interference fit. Table 1-35 Bushing Specifications All information subject to change without notice. 1-136 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Dimensions:
mm (in.) Inside Diameter of Bushing 52.05-52.07 (2.049-2.050) Outside Diameter of Bushing 57.080-57.100 (2.2472-2.2480) Inside Diameter of Bushing Bore 57.000-57.019 (2.2441-2.2448) Bushing Interference Fit 0.061-0.100 (0.0024-0.0039) Maximum Permissible Out-of-Round in Bushing Bore 0.01 (0.0004)