EPA07 MBE 4000 SERVICE MANUAL 4. Measure the outside diameter of the bushing. If the measurement exceeds 57.100 mm (2.2480 in.), replace the bushing. 5. Measure the bushing bore in the connecting rod for deformation. If the bushing bore is out-or-round by more than 0.01 mm (0.0004 in.), replace the connecting rod. 6. Rest the connecting rod on a flat surface. Using an appropriate drift, press the bushing into the connecting rod. 7. Measure the inside diameter of the bushing. If the measurement is shorter than 52.05 mm (2.049 in.), machine the inside contact surface of the bushing until the measurement is correct. All information subject to change without notice.
DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-137