Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.20 VALVES 1.20 VALVES The valves are controlled by mushroom tappets, pushrods, and rocker arms. The intake and exhaust valves are opened and closed by a valve-guided bridge. 1.20.1 Checking of Valve Lift Checking steps are as follows: NOTE: Do this procedure to determine, without removing the camshaft, if the camshaft, or parts of the valve train, have suffered excessive wear. If the camshaft itself is suspect, check the lift on every valve. 1. Remove the cylinder head cover(s). Refer to section 1.2.1. 2. Remove the inspection cover on the flywheel housing and install the engine barring tool (J–46392), Refer to section 1.17.1. NOTE: Check cylinders one at a time. 3.

Select the first cylinder. Using the engine barring tool (J–46392), rotate the flywheel until the piston in that cylinder is at ignition TDC. 4. Adjust the valve lash. See Figure 1-123. Refer to section 13.1. 1. Rocker Arm 3. Valve Spring Retainer 2. Valve Bridge Figure 1-123 Valve Lash and Valve Lift All information subject to change without notice. 1-138 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION