Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 1.22.1 Removal of Camshaft and Gear Assembly Removal steps are as follows: NOTE: Before removing the camshaft and gear assembly, clean the engine to prevent road dirt, grease, or other foreign matter from contaminating the exposed gears and other engine parts. 1. Drain the coolant from the engine. Refer to section 4.1.1. 2. Drain the engine oil. FALLING ENGINE To avoid injury from a falling engine, an adequate lifting device with a spreader bar and sling should be used to lift the engine. The sling and spreader bar should be adjusted so the lifting hooks are vertical to prevent bending the lifter brackets.

To ensure proper weight distribution, all provided lifter brackets must be used. NOTICE: A spreader bar must be used at all times in conjunction with the front and rear lifter brackets to lift the EGR engine to ensure that no engine damage will result. The brackets are designed to lift vertically. 3. Remove the engine from the vehicle. FALLING ENGINE To avoid injury from a falling engine, ensure the engine is securely attached to the engine overhaul stand before releasing the lifting sling. 4. Install the engine on an engine stand. Use OTC engine stand 1750A or equivalent and engine stand adaptor plate J-41576. 5. Remove the unit pumps. Refer to section 2.1.1. 6. Remove the vibration damper.

Refer to section 1.13.1. 7. Remove the fan support. Refer to section 4.3.1. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-159