Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.22 CAMSHAFT AND GEAR ASSEMBLY 19. Remove the tappets (valve lifters) from the block. Mark the tappets, in order, as removed. See Figure 1-142. 1. Cylinder Block 3. Tappet (valve lifter) 2. Camshaft Entry Hole 4. Fuel Pump Driven Gear Figure 1-142 Tappets 20. Clean and inspect the tappets. Replace the tappets if there are signs of damage or wear, or if any of the measurements do not meet the specifications listed in Table 1-46. Table 1-46 Valve Tappet Specifications [a] Measure the outside diameter of each tappet. [b] Measure the diameter of the tappet bore in the cylinder block. 21. Inspect the camshaft and gear assembly. Refer to section 1.22.1.1.

All information subject to change without notice. 1-162 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Repair Stage Specifications, mm (in.) Tappet Outside Diameter Standard 29.931-29.952 (1.1784-1.1792) Tappet Outside Diameter Repair Stage I 30.444-30.465 (1.1986-1.1994) Tappet Bore Diameter (in cylinder block) Standard 30.000-30.021 (1.1811-1.1819) Tappet Bore Diameter (in cylinder block) Repair Stage I 30.500-30.525 (1.2008-1.2018)