Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 1.22.1.1 Inspection of Camshaft and Gear Assembly Inspection steps are as follows: 1. Inspect the camshaft gear teeth for evidence of scoring, pitting, overheating or wear. Replace the camshaft and gear assembly if any of these conditions are found. Refer to section 1.22.1. 2. Check the hardness of the cam lobes and bearing journals on the camshaft. Listed in Table 1-47 is the permissible range for camshaft hardness. 3. Measure the diameter of each bearing journal. Measure the diameter of the bushing at each journal. See Figure 1-143. The camshaft measurement specifications are listed in Table 1-47. 1. Camshaft Gear 3. Camshaft 2.

Dial Gauge Figure 1-143 Measuring the Cam Rise 4. Mount the camshaft at the outer journals. NOTE: For all of the following steps, use a dial gauge. 5. Measure the radial runout of the cam basic circle. 6. Measure the cam rise of the intake valve cams. See Figure 1-143, Ref. I. 7. Measure the cam rise of the exhaust valve cams. See Figure 1-143, Ref. E. 8. Measure the cam rise of the unit pump valve cams. See Figure 1-143, Ref. U. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-163