Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.22 CAMSHAFT AND GEAR ASSEMBLY 9. Replace the camshaft if any of the measurements do not meet the specifications listed in Table 1-47. Table 1-47 Camshaft Specifications 1.22.2 Installation of Camshaft and Gear Assembly Installation steps are as follows: 1. Lubricate the tappets with a light coating of clean engine oil. 2. Install the tappets in the block, in order, as removed. 3. Install the camshaft and gear assembly. [a] Attach the camshaft pilot disc (J–46183–1, part of toolset J–46183) bolts finger tight to the front of the camshaft. [b] Thread the guide sleeve (J–41580–1, part of toolset J–46183) onto the pilot disc. NOTE:

Leave pilot disc attaching bolts finger tight in order to adjust guide sleeve during installation procedure. All information subject to change without notice. 1-164 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION What To Measure Where To Measure Value:

mm (in.) Unless otherwise noted Hardness of Surface At Cams and Journals 57–63 HRC Camshaft Radial Runout When Mounted on Outer Bearing Journals At Gear Seat 0.020 (0.0008) Camshaft Radial Runout When Mounted on Outer Bearing Journals At Cam Circle 0.025 (0.0010) Camshaft Radial Runout When Mounted on Outer Bearing Journals At Camshaft Journals 0.030 (0.0012) Minimum Valve Cam Rise–Above Basic Circle Intake Valve 7.3 (0.29) Minimum Valve Cam Rise–Above Basic Circle Exhaust Valve 8.2 (0.32) Camshaft Journal Diameter For New Camshaft 81.893–81.928 (3.2241–3.2255) Bushing Diameter At Camshaft Journals in Cylinder Block 82.000–82.035 (3.2283–3.2297) Gear Back Lash Cam Gear to Crank Gear 0.074–0.176 (0.0029–0.0069) Gear Back Lash Cam Gear to Air Compressor Gear 0.082–0.168 (0.0032–0.0066)