Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

2.1 ELECTRONIC UNIT PUMP 4. Mark the position of the intermediate plate in relation to the electronic unit pump body (See arrow A of Figure 2-9) and rest the electronic unit pump on the stop plate. Use a pencil or scribe for marking. Do not use any stamping tools. 1. Intermediate Plate 3. Torx Bit 2. Screw Figure 2-9 Magnet and Intermediate Plate 5. Remove all traces of paint from screw heads. Remove screws using the torx bit (P/N: 9045890210/00) and lift off the magnet together with the intermediate plate and model plate. (See arrow B of Figure 2-9). 6. Remove the intermediate plate and the model plate from the magnet. Wipe clean the sealing surface on the magnet, removing any excess fuel.

Clean the model plate and remove paint from the screw heads contact area. 7. Remove the two spacer seals and clean the intermediate plate. Do not damage sealing surfaces. All information subject to change without notice. 2-12 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION