Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 8. Mark the cross piece and anchor plate in relation to the electronic unit pump. (See arrow C of Figure 2-10). Use a marker; do not use a scriber or stamping tool. The cross piece should not be moved or twisted. 1. electronic unit pump 3. Cross Piece 2. Anchor Plate Figure 2-10 Cross Piece and Anchor Plate 9. Wipe clean the sealing surfaces on the electronic unit pump, cross piece, and anchor plate, removing any excess fuel. Clean the parts thoroughly. Do not remove the paint on the electronic unit pump; it is used as a reference point for the intermediate plate assembly. 10. Remove the stop plate. 11. Place a new stop plate under the electronic unit pump body.

12. Install the new seals in the intermediate plate. Protect the seals with a thin layer of high-temperature grease. 13. Place the intermediate plate on the electronic unit pump body. Observe the identification mark on the cross piece and anchor plate for the electronic unit pump body. The cutouts (see arrows D of Figure 2-11) at the opening in the intermediate plate must face towards All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 2-13