Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

2.1 ELECTRONIC UNIT PUMP the cross piece. The painted surface is a reference mark to the intermediate plate assembly on the electronic unit pump. 1. Anchor Plate 3. Intermediate Plate 2. Cross Piece Figure 2-11 Intermediate Plate 14. Place the magnet on the intermediate plate and place the model plate on the magnet. 15. Secure the model plate, magnet, intermediate plate, electronic unit pump and stop plate together using new screws. Hand tighten. 16. Tighten the screws in a crosswise pattern to 5 N·m (4 lb·ft), using torx bit (P/N: 9045890210/00). 17. Push the electronic unit pump O-ring installer (J–45373) onto the electronic unit pump. 18.

Install new O-rings on the electronic unit pump and install the electronic unit pump in the engine. Refer to section 2.1.3 for installation procedures. 2.1.3 Installation of electronic unit pump Installation steps are as follows: 1. Lubricate two new O-rings with a light coating of engine oil. All information subject to change without notice. 2-14 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION